[hmenu id=1]

Technical Tuesday: Common Reassembly Issues

This week, we’re taking a look at some common issues that can happen during reassembly. Assembling a Glock-pattern pistol is usually very easy, but sometimes there can be simple little issues that can cause reassembly to be a pain.

When your slide is hanging up, the first trick to try is to pull down on the slide lock a little bit, to allow the assembly to slide back on.

The other common issue folks can have is if the recoil assembly is not aligned properly, it can cause the top end to hang up. This is more common with the Glock stamped recoil spring assembly. Make sure the recoil spring is seated properly against the barrel.

Those two tricks can help with any hangups you may run into during reassembly.
Give us a call if you need any help 469.458.6808.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.